This is possible now that the SBS output doesn't rely on the global block timestamp;
the output will look like this:
MSG,8,111,11111,4AC954,111111,2015/02/08,17:57:53.917,2015/02/08,17:57:53.936,,,,,,,,,,,,0
MSG,7,111,11111,392AEB,111111,2015/02/08,17:57:53.744,2015/02/08,17:57:53.936,,15375,,,,,,,,,,0
MSG,8,111,11111,392AEB,111111,2015/02/08,17:57:53.917,2015/02/08,17:57:53.936,,,,,,,,,,,,0
MSG,6,111,11111,800387,111111,2015/02/08,17:57:53.919,2015/02/08,17:57:53.936,,,,,,,,4745,0,0,0,0
where the "receive timestamp" (first time column) goes backwards to reflect the original reception
time of the delayed message, but the "forwarded timestamp" (second time column) reflects the actual
forwarding time.
the message being emitted immediately.
Fix computation of reception time so it's more sensible (the block timestamp
is some time after reception of the _end_ of the block, not the start) - this
means that message-emission times are always later than message-reception
times in SBS output, which is a bit more sensible.
Use clock_gettime in preference to ftime.
(except in --net-verbatim mode, where we emit them all)
Move aircraft tracking into track.[ch].
Clean up references to "interactive mode" when tracking
aircraft - we always track aircraft, even in non-interactive
mode.
since we have 8 bits spare, so there's no chance of confusing it
with an ICAO address, and we can safely use the filter table to match
future messages without also matching equivalent ICAO addresses.
Switch signalLevel back to a power measurement, don't put SNR in there.
But make it a 0.0 - 1.0 double so we're not scaling everywhere.
Adjust for the amplitude offset when calculating power.
Adapt everything else to the new scheme.
This is adapted from the FlightAware fork, with some cleanup and
modifications needed to work with the net-cleanup changes.
Inclusion of "verbatim" TSV data read from an AVR-format input
connection is not supported.
Pull #54 breaks the Windows version of dump1090 due to a bug in the
inet_aton() windows function.
1) Fix the bug in the windows inet_aton()
2) Modify the command line code to strdup() the command line string.
3) Leave the Modes.net_bind_address pointer NULL if no command line
specified
Pull #54 permits changing the default bind address. The default was
127.0.0.1. This prevents external access unless a command line switch is
used. Since many users of dump1090 are using dump1090 as remote receiver
heads for programs such as plane plotter, this is undesirable. If you
want to lock down your RPi for local use only then use the command line
switch. If not, retain legacy open mode by binding to 0.0.0.0 by
default.
Mostly refactoring the common code that was duplicated
between the different output types so that there aren't
many copies floating around.
This introduces "struct net_writer" to store the state of a
particular type of output service - buffers, time of last write,
connection count etc. prepareWrite() / completeWrite() give access
to the buffer and handle the actual writes and flushing when needed.
Heartbeat and time-based flushing move into a generic periodic-work
function.
Update the SBS output code to use the new infrastructure. This makes
a big different to CPU use when under load.
